|
Click image to Zoom |
Home Guard Charge controller uses PWM charging Technology, so that as the battery reaches full charge, the PWM pulses slower, gradually tapering off the charge. Pulsing is good for the batteries since it gently mixes the electrolyte, preventing stratification and sulphation. Low voltge disconnect protects the batteries from severe discharge by shutting off loads before the battery voltage drops to damaging levels
Temperature compensation adjusts the set point voltages according
to the ambient temperature. |
- Excellent charging algorithm
- Temperature compensated set points
- Adequate protections and indications
- Negligible voltage drops
- Negligible self consumption
- Offers long life to batteries
- Non-corrosive terminals
- Compact in size and easy to install
|
Top
| |
HomeGuard - 6A |
| General |
| Applicati2n |
Solar electrification |
| Use |
Battery Charging and load control |
| Operating temperature |
-10°C to 50°C |
| Storage temperature |
-25°C to 85°C |
| Charge controller type |
Discrete component based |
| Charging type |
Two step series PWM |
| Battery temperature compensation |
-4mV to –5mV/°C/cell |
| Solar Module size (Max.) |
90Wp |
| Indications |
Charging, Low Battery, Low Battery warning |
| Electrical |
| Nominal system voltage |
12V DC |
| Charging current |
6A |
| Load current |
6A |
| Charge controller efficiency |
>95% |
| Idle consumption |
<5mA |
| Drop between PV and Battery |
~490mV |
| Drop between Battery and Load |
~550mV |
| Protections |
Against module reverse current
flow, reverse battery and overload, short circuit, under and over voltage, under and over temperature |
| Overload protection |
Provided |
| Mechanical |
| Fixing |
Wall mounting with screws |
| Case |
Injection Moulded Engineering
Plastic |
| Cable entry size |
4.0 Sqmm (Max) with fork terminal |
| Size (Shipping)(mm) |
115 X 100 X 40 |
| Weight (Shipping) |
180gms |
| Note: Specifications subject to change without
notice. Check for latest update |
Top
| HomeGuard series |
| Ordering code |
Model |
System Voltage |
Max Module Wattage |
Max Charging Current |
Max Load Current |
Battery Type |
| 029-005 |
SCC-M0606C |
12V DCV |
90Wp |
6A |
6A |
Flooded |
| 029-006 |
SCC-M00606D |
12V DC |
90Wp |
6A |
6A |
VRLA (SMF) |
Top
|
|
