|
Click image to Zoom |
Ammini Solar Pvt. Ltd. provides the perfect solution for electricity
generation from sunlight in an efficient and environment friendly
manner. Ammini Solar modules are designed to withstand the toughest
environmental conditions and manufactured in compliance with the most
stringent quality standards. Ammini solar modules are covered by a
10 year limited warranty on power output.
The solar module contains 36 mono or poly crystalline silicon solar
cells connected in series. All cells are electrically matched to assure
the maximum power output possible. One solar module can charge a 12
volt battery using a charge controller. System voltages of 24 volt
and higher can be obtained by connecting modules in series. Higher
currents can be obtained by connecting modules in parallel. |
- Highly efficient mono-crystalline or poly crystalline silicon
solar cells
- Uses 36 numbers of solar cells
- Designed for maximum reliability and minimum maintanence
- Highly resistant to rain, water, abrasion, hail impact, and
environmental factors.
- Light weight anodized aluminium frame and pre-drilled mounting
holes for easy installation
- All proven products. Only materials with extensive field experience
used.
- 10 years product warranty.
|
Top
A high impact resistant and highly transparent tempered glass plate,
in front side of the module, offers adequate protection against ednvironmental
hazards such as rain, hail, snow, ice and storms. The back of the
solar module consists of a Tedlar-Polyster-Tedlar foil, offering reliable
protection against penetration of moisture and dirt.
The solar cells are embedded in ultraviolet stabilized ethyl vinyl
acetate (EVA). The highly corrosion resistant anodized aluminium alloy
frame provides structural support for the solar module. |
| The junction box provides a high quality, dust and watertight housing
for the rigid connection block. It is fitted with one cable gland.
This cable gland can be used for taking out electrical connection
from solar module. The junction box is fitted to aluminium frame for
better mechanical strength. |
| Inside the junction box there is a 3 pole connection block. Two
bypass diodes can be incorporated in to the junction box offering
an adequate "hot spot" protection of the solar cells. Solar
modules of 20W and below are connected with junction box having 2
poles. There is no provision for connecting bypass diodes in these
modules.
The solar modules are subjected to intensive quality control both
during and after production an are tested extensively. |
Top
|
|
